Honda CR-Z warns of tyre pressure: what now?

Honda CR-Z warns of tyre pressure: what now?

Tyre pressure problems on the Honda CR-Z are often easy to resolve, but a recurring warning calls for more than just adding air. Too little air can make the tyres wear faster and reduce grip. A flashing light can instead point to a fault in the measuring system. More information on other issues can be found under problems with the Honda CR-Z. Start with one question: is a tyre losing air, or is the car not trusting the reading?

Why does the Honda CR-Z keep warning about low tyre pressure?

A tyre pressure warning light that stays on continuously usually indicates pressure that is too low. First, check all four tyres with a pressure gauge. According to Honda, a drop in outside temperature and changes in altitude can also affect pressure and trigger a warning. That explains why the message sometimes appears for the first time on a cold morning.

If the warning returns after inflating the tyres, compare the pressure in all four. If the same wheel keeps losing air, a puncture is more likely than a temperature effect. A screw in the tread is one possibility, but also check the valve and the seal between tyre and rim. A tyre that keeps losing a few tenths of a bar needs investigating. Repeatedly topping it up only hides the cause.

The behaviour of the light provides a second clue. If it flashes for about a minute and then stays on, that more often points to a fault in the tyre pressure monitoring system, also known as TPMS. The same applies to a message such as ‘Check TPMS system’. With the message ‘Check tyre pressure’, the first thing to do is measure the tyre pressure.

Honda CR-Z tyre pressure by model year and tyre size

For the Honda CR-Z, one fixed tyre pressure per model year is not enough. The correct value also depends on the variant and tyre size. According to the official specifications, the 2011 model year CR-Z was supplied with 195/55 R16 tyres. For each model year, check which size is actually fitted to the car, especially after a wheel change.

The following values are a guide for commonly used CR-Z sizes:

  • 195/55 R16: 30 psi front and rear, about 2.1 bar.
  • 205/45 R17: 32 psi front, about 2.2 bar, and 30 psi rear, about 2.1 bar.

The sticker in the door pillar and your car’s handbook remain the authority. That way, you avoid taking over a value intended for a different variant or tyre size. Do not use the maximum pressure on the tyre sidewall as your guide: that indicates the maximum the tyre may have, not the pressure Honda specifies for the car.

Check the tyres when they are cold, for example before you set off. After a drive, the air in the tyre heats up and you will temporarily measure a higher pressure. According to Honda, the value on the dashboard can also differ slightly from a measurement taken with a pressure gauge. If in doubt, check with a reliable handheld gauge.

Honda CR-Z

Incorrect tyre pressure has noticeable consequences

With pressure that is too low, a tyre deforms more during driving. This creates extra heat and can make the shoulders of the tread wear faster. The car may also respond less accurately to steering inputs. Ignoring a warning is therefore not a good choice, even if the CR-Z still seems to drive normally.

Pressure that is too high is not the answer either. The tyre is then loaded differently, which can affect grip and the wear pattern. So do not just check whether air needs to be added; bring each tyre back to the value specified for the car. Check the tread straight away: unusual wear can indicate that the tyre has been driven for a long time at the wrong pressure.

From low pressure to a persistent TPMS warning

On the CR-Z, sensors in the wheels transmit tyre pressure to the car. A warning that remains even though all tyres have the correct pressure may therefore have a different cause from air loss. Especially in an older car, it is important to check the sensors: the built-in batteries can run flat over time.

The following signs help determine the next step:

  • One tyre keeps losing pressure: have the tread, valve and rim edge checked for leaks.
  • The warning appears mainly in cold weather: check all tyres when cold and set them according to the door pillar sticker.
  • The light flashes and then stays on: have the TPMS read out.
  • The warning started after a tyre change: check whether a sensor is damaged or not being recognised.
  • A new sensor is not recognised: have the programming, sensor ID and suitability for the model year checked.

A replacement sensor does not always work immediately after fitting. The correct vehicle protocol must be set and the car must recognise the sensor ID. Sometimes the warning only disappears after a short drive. So do not ask a tyre specialist only to check the pressure, but also to confirm that all four sensors are communicating. A rattling noise from a wheel after a tyre change is also a reason for inspection: a sensor may have come loose.

How to tackle tyre pressure problems on the Honda CR-Z

Work from a simple pressure check towards a diagnosis of the system. That way you avoid replacing a sensor when a leaking valve or cold weather explains the warning. Follow these steps:

  1. Check the pressure of all four tyres when they are cold.
  2. Compare the tyre size and measured pressure with the sticker in the door pillar.
  3. Inflate the tyres to the specified pressure and look for a leak if pressure keeps dropping.
  4. If necessary, carry out the TPMS calibration according to your variant’s handbook.
  5. Take a short drive and check whether the warning disappears.
  6. If the light keeps flashing or ‘Check TPMS system’ appears, have the sensors read out.

The calibration procedure differs by model year and variant. Some CR-Zs have a button under the dashboard; other variants require a scan tool. So do not rely on a reset procedure you found for another model year. Check the handbook for your own car before resetting the system.

Make checking tyre pressure when cold a monthly habit and also check the tyres before a long journey or after a significant temperature change. Does the warning keep coming back? Then check separately for pressure loss and a TPMS fault. That way you will find the cause more quickly. On the Carnews website you can find more about Honda CR-Z issues, tyre maintenance and other automotive technology. That information helps you to approach your next check in a focused way.

Frequently asked questions

According to the available information, the Honda CR-Z does not use indirect TPMS, but pressure sensors in the four wheels. The system can signal pressure loss, but subtle differences are not always shown exactly and the dashboard reading may differ slightly. For that reason, always check small pressure differences with a reliable pressure gauge on cold tyres.