Faulty injectors in a Volvo S60 often mean hard starting, rough running and noticeable loss of power. These symptoms do not prove that the injectors themselves are broken. Fuel pressure, wiring or sealing can also be the cause. So have a targeted diagnosis carried out first before you have parts replaced on a Volvo S60 with known issues. That way you avoid an expensive repair based on the wrong assumption. Read which signs matter and how a garage identifies the cause.
What are the symptoms of faulty injectors?
The injectors meter fuel for each cylinder. A dirty, worn or faulty injector no longer delivers the right amount at the right moment. As a result, combustion becomes disturbed. The exact symptoms vary by engine. The nature of the fault also determines the complaints.
If you suspect faulty injectors in a Volvo S60, look out for the following symptoms:
- The engine is hard to start, especially when cold.
- The car stutters or hesitates when accelerating.
- The engine produces less power than normal.
- The idle speed does not remain steady.
- Fuel consumption increases noticeably.
- Black or white smoke comes from the exhaust.
- You can smell fuel around the car or in the cabin.
- The engine warning light comes on.
A single isolated symptom is not enough for a reliable diagnosis. Low fuel pressure or a weak battery, for example, can also cause starting problems. Loss of power can likewise have several possible causes. The combination of symptoms, fault codes and measurements gives a garage a more useful picture.
‘ Good diagnosis prevents a serviceable injector from being replaced unnecessarily. ’
Why does a Volvo S60 start badly?
With a poorly functioning injector, one cylinder receives too little fuel. In other cases, the cylinder gets too much fuel. As a result, the engine sometimes has to turn over for longer before it starts. Especially with diesel engines, internal leakage can reduce pressure in the fuel rail. Without sufficient rail pressure, combustion does not get going properly.
An injector is sometimes mechanically defective. A simple electrical test then shows no deviation. Contamination or wear disrupts the spray pattern. The fuel is then no longer distributed properly in the cylinder. You may first notice this as difficult starting and only later as hesitation or smoke.
The cause is not always the injector itself. A poor connector connection or corrosion can produce the same effect. Cable damage may also interrupt the control signal. A worn seal or loose mounting also deserves attention. Good diagnosis prevents a serviceable injector from being replaced unnecessarily.
How does a garage test the injectors?
A garage tests the injectors of a Volvo S60 with electrical measurements, a pressure test and an operational test. Reading fault codes alone is usually not enough. A fault code shows which cylinder is behaving abnormally. The code does not automatically tell you which component is causing the problem.
Read fault codes and measured values
The mechanic connects diagnostic equipment and checks stored faults. Cylinder-specific fault codes and abnormal correction values are relevant here. The data help focus the investigation on a particular cylinder or the fuel system.
Check connectors and wiring
The garage then checks the electrical connections. Oxidation and corrosion disrupt the electrical contact. A broken wire or loose connector interrupts the control signal. This check is important, because an electrical problem produces almost the same symptoms as a faulty injector.
Compare injector resistance
A resistance test identifies an injector with an electrical anomaly. The mechanic compares the values of the injectors with one another. However, a normal value does not rule out a mechanical problem.
Carry out a return-flow test on a diesel
With a diesel engine, the garage carries out a return-flow test. This is also called a leak-back test. The test measures the return fuel per injector. An injector with clearly more return fuel may prevent the required rail pressure from being reached.
Check fuel pressure and operation
The garage measures the fuel pressure. This allows the mechanic to rule out a problem with the pump or pressure regulation. Sometimes the mechanic swaps a suspect injector to another cylinder. The garage then checks whether the fault moves with it. If so, that strongly points to a defective injector.
How much does replacing Volvo S60 injectors cost?
Testing and replacing injectors on a Volvo S60 is often an expensive repair. If several injectors are replaced, the total cost according to the stated estimate is between €1,000 and €2,000.
The actual bill depends on:
- the engine type;
- the number of faulty injectors;
- the choice of parts;
- labour costs.
So ask the garage for an itemised quotation. Diagnosis, parts, fitting and any additional work should all be listed separately. After installation, the garage programmes the injector codes if necessary or relearns the engine management values.
Do not have all injectors replaced automatically just because one unit is out of spec. Sometimes replacing only the faulty injector is technically possible. The garage should first assess the condition of the other injectors. It then compares the corresponding measured values. If several injectors show significant wear, replacing them together may be the wiser option.
What affordable alternatives are there?
Besides original injectors, there are other options. Think of new injectors from aftermarket manufacturers and remanufactured units. An alternative must be suitable for the exact engine code. The part must also meet the required specifications. Choosing only on the basis of the lowest price carries risks.
- New injectors from a well-known parts manufacturer are sometimes cheaper than parts in Volvo packaging.
- Professionally remanufactured injectors are an option if they have been tested and come with a test report.
- A Volvo specialist often buys more selectively. This specialist also has experience with suitable part numbers.
- Replacing only the faulty injector saves money if the other injectors are demonstrably working well.
When it comes to remanufactured injectors, ask which parts have actually been replaced. Also ask how the injector was tested. In addition, check the warranty terms and the part number. Used injectors without test data give little certainty about the degree of wear. Leakage and an incorrect spray pattern will also remain unclear. A cheap choice can therefore still lead to double fitting costs.
Can you keep driving with faulty injectors?
It is not wise to keep driving for long. An injector that sprays too much fuel disrupts combustion. It also feeds extra fuel into the exhaust system. That puts other components under strain.
Have the car checked as soon as possible if you notice the following:
- serious hesitation;
- heavy smoke;
- a strong smell of fuel.
Stop driving if fuel is leaking or the engine is running very unevenly. A leak is a safety risk. A flashing engine warning light also calls for immediate attention. This points to misfires, meaning ignition or combustion faults. If in doubt, have the car transported rather than drive it any further.
How do you reduce the risk of new injector problems?
Not every fault can be prevented. Good maintenance does, however, reduce the chance of contamination and fuel supply problems. Replace the fuel filter at the service intervals specified by the manufacturer. Use suitable fuel and have starting problems or power loss investigated in time.
Ask a mechanic to check the connectors first. Also have the seals inspected. Finally, ask them to pay attention to loose or damaged mountings. A small fault around the injector sometimes causes the same symptoms as an internal defect.
So choose a full diagnosis. That way, the garage investigates not only the visible symptom, but also the underlying cause.
On the Carnews website you will find more information for car enthusiasts. Topics include:
- problems with Volvo models;
- engine faults;
- maintenance;
- other practical car topics.
Discover the related articles on Carnews and be better prepared for diagnosis, repair and maintenance.
Frequently asked questions
Symptoms of faulty injectors in a Volvo S60 include hard starting, hesitation when accelerating, loss of power and increased fuel consumption. Uneven idling, misfires and black or white exhaust smoke can also occur. A strong smell of fuel around the car or in the cabin may likewise point to injector problems.
Reconditioning worn injectors yourself is usually not advisable: it requires specialist measuring and calibration equipment. First have it checked whether the injector is actually worn, because contamination, seals, wiring or fuel pressure can also be the cause. A specialist can determine whether professional reconditioning is possible or whether replacement with a suitable quality part is needed.
Faulty injectors mainly cause hesitation, stuttering and a noticeable loss of power under hard acceleration during spirited driving. The engine may run unevenly, misfire, consume more fuel and produce black or white smoke. Continuing to drive under heavy load can also cause additional damage to the engine and catalytic converter.

















