An oil leak from the head gasket, the seal between the cylinder head and engine block, or from the shaft seals of the Citroën C3 Picasso calls for a careful diagnosis. Oil on the outside of the engine block does not prove that the head gasket is faulty. There is no fixed mileage at which these seals start to leak on all engines, not even after 100,000 kilometres. Moreover, oil can drip onto the ground far from its source. Which traces show where the leak starts?
Where does oil under the bonnet come from?
Start at the top of the engine, even if there is a drop hanging under the gearbox. Oil runs down the block. Through the undertray, the oil can end up elsewhere. On the C3 Picasso, the valve cover, vacuum pump, oil filter housing and the seals around the crankshaft are key inspection points. On the 1.6 HDi, the turbo oil lines and crankcase ventilation are added to the list.
The fluid itself gives an initial clue. Engine oil is liquid and often brown or black. Gearbox oil can be lighter in colour and often has a strong sulphur-like smell. Thick grease flung around a driveshaft or inside the wheel arch is more likely to point to a damaged CV joint boot. Do not rely on colour alone: used transmission oil can also be dark.
Also pay attention to where the first oil trace appears. Oil around the spark plugs or coils on a petrol engine is more in keeping with a leaking valve cover than with a head gasket. If the engine is wet on the timing side, both higher-up seals and the front crankshaft seal are possible. A wet patch under the car is therefore only the start of the diagnosis.
When does an oil leak point to the head gasket?
The head gasket seals the connection between the cylinder head and the engine block. A fault can allow oil to leak out. Even so, the head gasket is not the first suspect if you only see oil on the block. Look first for the highest wet point. Also check whether the engine is losing or consuming coolant, or overheating.
These signs justify further investigation into the head gasket:
- coolant loss with no visible leak;
- bubbles or rapid pressure build-up in the expansion tank after a cold start;
- persistent white exhaust smoke when the engine is warm;
- oil in the coolant or coolant in the engine oil;
- rough running or loss of compression.
A light mayonnaise-like residue under the oil filler cap is not proof in itself. Short trips can cause condensation. If several signs are present, have a CO₂ test carried out on the cooling system; this can detect exhaust gases in the coolant. A compression test or cylinder leak-down test helps when the engine is also running unevenly. Never open a hot expansion tank: the cooling system is pressurised.

How does a head gasket repair on the C3 Picasso work?
Replacing a head gasket is more work than renewing an external seal. The cylinder head has to come off, after which the garage assesses the sealing surfaces and the condition of the head. The correct gasket and fitting data depend on the exact engine version. For that reason, have the engine code checked before parts are ordered or a repair price is agreed.
Ask the garage to record the diagnosis first. Where does the oil trace begin? Are there signs that oil, coolant or combustion gases are going the wrong way? Without that evidence, an expensive head gasket repair may leave the actual leak untouched. If oil is running only along the upper edge of the cylinder head, the valve cover should be dealt with first.
When replacing a valve cover gasket, the contact surfaces must be clean and the gasket must sit flat. Use liquid gasket only where the manufacturer specifies it. Bolts tightened too firmly can warp the cover, meaning even a new gasket will keep leaking.
Which shaft seal is leaking on the Citroën C3 Picasso?
With a leaking shaft seal, several seals may be meant. The crankshaft has one seal on the timing side and one on the gearbox side. There are also driveshaft seals where the driveshafts exit the transmission. The location therefore determines both the diagnosis and the repair.
Oil on the timing side calls for prompt inspection
Oil around the crankshaft pulley or behind the timing cover may come from the front crankshaft seal. A seal higher up can also leak. The oil then runs towards the timing side. For a reliable assessment, the cover sometimes has to be removed. If the timing belt is contaminated with oil, have it checked immediately: oil can damage the belt material. If contaminated, the belt kit may need replacing.
A wet transition between the engine and gearbox
If there is oil between the engine and gearbox, mechanics sometimes suspect the rear crankshaft seal. However, the fluid may also come from the transmission, the sump or a higher-up engine seal. Repairing the rear crankshaft seal usually requires removing the gearbox. So establish which fluid is leaking before that work begins.
Oil around the driveshaft outlet
A wet gearbox around the point where the driveshaft exits points to a leaking driveshaft seal. Also check the subframe and see whether the transmission oil level is dropping. After work on a driveshaft, a seal may have been damaged during removal or refitting.
During repair, the shaft must sit fully home and the seal must be fitted straight, at the specified depth. Also inspect the running surface on which the seal seals. A worn shaft can start leaking again, even with a new seal. After reassembly, have the gearbox oil level checked.
How to track the leak down properly
Clean the engine to make it easier to find the source of the leak. According to Citroën’s user information, you should check the engine oil level on level ground. If needed, top up a small amount of oil and measure again. Note the level and mileage when you discover a leak. That makes it possible to see whether the loss is increasing.
Then follow these steps:
- With the engine cold, check the oil level and coolant level.
- Clean the engine, transmission and undertray; protect electrical connections.
- Take a short test drive and then look for the highest fresh oil trace.
- Record the location with photos and note whether the leak mainly appears after driving.
- If in doubt, have suitable UV dye used to trace the source.
Do not keep driving if the oil pressure warning comes on, the oil level drops quickly, the engine overheats or there is smoke from the engine bay. Oil dripping onto hot exhaust parts or a contaminated timing belt also calls for immediate attention. With a small leak and no such signs, checking the levels remains important. Only replace parts once the source is known.
On the Carnews website you will find much more about problems, maintenance and repairs for the Citroën C3 Picasso and other cars. Discover more on Carnews and compare the symptoms before you have a repair carried out.
Frequently asked questions
In the early stages of a head gasket leak, the engine may run unevenly, coolant level may drop slightly, pressure may build early or bubbles may appear in the expansion tank, and there may be a mayonnaise-like residue under the oil cap. A leaking crankshaft or driveshaft seal often first shows up as a thin film of oil, a burning or sulphur smell, light smoke after driving, or gradually falling engine or transmission oil. With a rear crankshaft seal, you may also notice the clutch beginning to slip or judder before there are any oil drips under the car.
Extreme thermal loading during track use can cause the cylinder head and engine block to expand or distort unevenly, causing the head gasket to lose its seal. In tuned engines, higher combustion pressures and temperatures intensify this effect, especially if cooling, ignition or the fuel mixture have not been adjusted sufficiently. As a result, combustion gases can enter the cooling system, leading to pressure build-up, coolant loss and ultimately head gasket failure.
Clean the engine and, after a short test drive, check where the oil appears first. Excessive crankcase pressure points to a blocked/faulty crankcase ventilation system and often causes leaks at multiple gaskets or seals, sometimes with strong vapour or pressure at the oil filler cap or dipstick. A worn shaft seal usually gives a localised leak directly around the crankshaft or camshaft, visible behind the timing cover. Also check for oil on the timing belt; if contaminated, it should be assessed immediately and usually replaced.




