When electric windows suddenly stop working

When electric windows suddenly stop working

Faults with the window mechanism and the electric windows are annoying, but they do not always point straight away to a broken window motor. In the Alfa Romeo Junior, several causes are possible. Think of a dirty switch, lost calibration, damaged wiring or resistance in the window guide. By looking closely at the symptoms, you can avoid unnecessary replacement of parts. That way, you can work out what may be going on.

Why are my electric windows not working?

An electric window consists of more parts than just the glass and a button. The switch sends an electrical signal. The motor then moves the window up or down via a regulator. When there are reports of Alfa Romeo Junior problems, faults in comfort systems also deserve attention. There are still very few widely confirmed cases of a structural fault in the window mechanism.

If the window does not respond at all, the cause may lie in the power supply or control system. If the glass does move, but slowly or jerkily, a mechanical problem is more likely. Dirt in a switch can also mean the contact is not made properly every time.

Common possible causes are:

  • A dirty or worn window switch.
  • A faulty fuse or interrupted power supply.
  • Loose wiring or a poor plug connection.
  • A worn window motor or window regulator.
  • Dirt or resistance in the seals and guides.
  • Lost calibration after work on the battery.
  • A fault in the electronic control system.

First check whether the problem affects one window or several. If all the windows are not working, a shared fuse, power supply or control module is more likely. If only one window has failed, the local switch, motor, wiring and regulator are more likely suspects.

These signs point to a window mechanism fault

A window regulator is the mechanism that moves the glass and holds it in place. Many designs use cables and guides. These parts can wear or seize up. The motor may still be audible, but the window hardly moves.

Watch for the following signs when operating it:

  • The window moves jerkily or noticeably slowly.
  • You hear a clicking, ticking or scraping noise from the door.
  • The glass runs crookedly in the guide.
  • The window drops back slightly after being closed.
  • The glass unexpectedly falls down into the door.
  • You can hear the motor running, but the window stays put.

Do not keep using the window repeatedly if the glass is running crooked. Stop operating it as soon as you hear scraping noises as well. Carrying on can damage the cables further. The glass can also come out of the guide. Have the door checked before you use the system again.

How do I reset the window control system?

After the battery has been disconnected or gone flat, the window control system may forget its end stops. The automatic function then sometimes no longer works, or the window does not close in one movement. Re-learning it can solve this if there is no mechanical or electrical fault.

A commonly used procedure for re-learning is:

  1. Switch on the ignition according to the car’s instructions.
  2. Close all doors.
  3. Fully lower the relevant window.
  4. Hold the switch briefly when the window is fully down.
  5. Then raise the window fully.
  6. Hold the switch at the top again for a few seconds.
  7. Then check the automatic opening and closing function.

The exact procedure may vary by version or software release. For that reason, consult the Alfa Romeo Junior owner’s handbook. If the function still does not work after a correct reset, it is wise to have it read out by a dealer or specialist. A reset does not repair a faulty motor, cable or switch.

Dirt in switches can cause faults

A window switch gets used a lot and can become dirty over time. Dust, moisture and other residue can block the button. They can also disrupt the electrical contact. A window may then respond sometimes and not at other times, depending on the position of the button or the pressure on it.

Carefully clean only the outside with a dry, soft cloth. Do not use large amounts of cleaning product and never pour liquid around the switch. Cleaning the contacts requires the control panel to be removed. Have this done if you do not have experience with door panels and electrical connectors.

In the event of a fault, also test the switch on the other door, if the car has that option. The window may well work from one control point. In that case, the other button or connection may be faulty. If the window does not respond from any switch, diagnosis should continue with the fuse, wiring, motor and regulator.

Is replacing the window motor expensive?

The cost of replacement depends on the fault and access within the door. Sometimes a switch or plug connection is the only cause. In other cases, the window motor and window regulator have to be replaced together. This takes more parts and labour.

The final bill is mainly determined by:

  • The part that is actually faulty.
  • Replacing only the motor or the complete regulator.
  • The time needed to remove and refit the door panel.
  • The need for diagnosis and re-learning.
  • Warranty terms and the age of the car.

First ask the workshop for a diagnosis and a quote. An audible motor, for example, does not automatically mean that motor is broken. The cable mechanism may be broken while the drive is still turning. Targeted checking prevents a working part from being replaced unnecessarily.

Alfa Romeo Junior

Can I operate electric windows manually?

Electric windows normally do not have a handle that lets you open or close them manually if a fault develops. Pulling on the glass yourself is not a good solution. You could damage the window regulator, set the glass crooked or put strain on parts inside the door.

Cover the opening temporarily if the window is open and rain is expected. Make sure you do not damage the paint or rubber seals while doing so. A workshop can remove the door panel and, if necessary, secure the glass in the closed position. This is a temporary measure until the motor, regulator or control system has been repaired.

How to reduce problems with electric windows

A window fault is not always avoidable, but slight resistance can often be spotted early. Keep window seals and guides clean and carefully remove sand or other dirt. Do not operate frozen windows, as the motor and cables then have to work against a great deal of resistance.

During a test drive or handover, test all the windows individually. Check both the normal operation and the automatic function. Listen out for tapping, creaking and scraping noises. Have a window that falls back, moves crookedly or does not close fully checked in good time.

On the Carnews website you will find much more information on car problems, maintenance, technology and points to look out for on different models. Discover the related topics and use the practical tips to spot faults more quickly.

Frequently asked questions

The most common causes are wear or breakage of the window regulator and cable mechanism, a faulty electric motor or problems with wiring and control. Dirty or dried-out seals, misaligned guides and the tight fit of frameless windows can also overload the mechanism. After a battery change or software reset, incorrect calibration of the end stops can also occur.

Disconnect the negative battery terminal, consult the model-specific manual and remove all hidden screws, switches and trim covers with plastic trim tools. Release the clips one by one from the lower edge and lift the door panel up, without pulling on cables or connectors. Secure the window glass with tape, disconnect the plug and retaining bolts from the motor and replace the motor without forcing the lifting mechanism. Test the operation before refitting, put the moisture barrier and clips back correctly and, if necessary, recalibrate the window end stops.

Alfa Romeo is mentioned more often in connection with electric window faults, such as sticking windows, faulty mechanisms and reset problems.