A pre-purchase inspection of an Alfa Romeo Giulia starts with the service history and ends after a cold start, an extended test drive and an inspection on a lift. Pay particular attention to the battery, cooling system, automatic gearbox, brakes, water tightness and electrical systems. During a short drive, faults in these components can easily go unnoticed. Also see the overview of Alfa Romeo Giulia problems on Carnews. Where do you begin when the car is standing in front of you?
Which details should you check before the test drive?
First ask for service invoices, not just a filled-in service book. Compare the mileage readings and see which work was actually carried out. Note when the battery, brakes, tyres and fluids were replaced. On a 2.2 diesel, invoices for maintenance or repairs to the diesel particulate filter, exhaust gas recirculation (EGR) and AdBlue system are also relevant.
Using the vehicle identification number (VIN), check with an official Alfa Romeo dealer which recall campaigns and software updates apply to this example. These are manufacturer measures to remedy known defects or software issues. Ask for proof that the work has been carried out. For a car from the first production years, from 2016 onwards, examine the service records and the operation of the electronics particularly carefully. That is not a reason to write off such a Giulia, but it is a reason to take unexplained warnings seriously.
‘A warning that disappears after clearing the codes does not prove the problem has been fixed.’
Start the Giulia inspection with a cold car
Arrange the viewing so the engine has been standing for several hours beforehand. Before starting, check the coolant level and look underneath the car for fresh traces of oil or coolant. On a cold start, a weak battery, unusual engine noises and starting problems are easier to spot. Make sure the warning lights go out after starting. An engine that is already warm can hide such faults.
The 12V battery deserves a separate test. Low voltage can disrupt several systems at once. That can cause multiple dashboard warnings to appear without every mentioned component actually being faulty. Ask a workshop to test the battery under load and the charging system. Simply measuring battery voltage while the car is stationary does not provide enough certainty about its condition.
Then use diagnostic equipment that can also read the transmission, ABS, airbags and body electronics. Record any stored fault codes before anyone clears them. If a warning appears, ask for a diagnosis of the cause: a warning that disappears after clearing the codes does not prove the problem has been fixed.

How do you spot leaks in the cooling system and cabin?
Check the cooling system both when cold and after the test drive. Look around hoses, connections and the front of the engine for moisture or dried coolant. A sweet smell, vapour or a temperature that does not remain stable calls for further investigation. Do not open the cooling system cap when the engine is hot. If in doubt, ask a workshop to carry out a pressure test.
On the 2.0 turbo petrol and the Quadrifoglio’s 2.9 V6 biturbo, it is also sensible to inspect the connections around the turbochargers for leaks. While accelerating, look for smooth power delivery. Loss of power, scraping noises or blue exhaust smoke are reasons for further investigation.
Water leaks require a different check. Lift the boot mat, feel along the edges of the floor covering and inspect the seals on the doors and tailgate. Watch for misted lamp units, a damp smell and stains under the trim. If the seller agrees, use a gentle stream of water to wet the outside of the windows and seals. Then inspect the interior. Do not aim a hard jet directly at the seals: that does not mimic a normal rain shower.
Test the automatic gearbox and torque converter cold and hot
Many Giulia models have an eight-speed automatic gearbox. With the car stationary, shift from P to D and R and pay attention to any clear delay or heavy jolt. Then drive slowly through a parking bay and check whether the car manoeuvres without jerking. Repeat that check after the driveline has warmed up.
The torque converter connects the engine and the automatic gearbox and can lock up during steady driving. At a constant speed, watch for recurring vibrations or fluctuations in engine speed. Such complaints do not by themselves prove a faulty torque converter: tyres or other parts of the driveline can also cause vibrations. Have a specialist establish what is causing the vibrations before accepting a repair quote.
Allow at least twenty to thirty minutes for the test drive. Test gentle acceleration, downshifts and firmer acceleration once the engine is up to temperature. On a Q4 with four-wheel drive, unusual drivetrain noises and uneven tyre wear deserve extra attention.
‘From the outside of a wheel, you cannot see everything.’
What do the brakes, tyres and steering tell you?
The Giulia steers directly. That makes pulling to one side and vibrations through the steering wheel easy to notice during a test drive. Check the inside edges of the tyres for uneven wear and, if in doubt, have the wishbones, steering components and alignment checked. A worn tyre may be a clue, but it does not tell you which part is the cause.
On a safe road, carry out a few gentle and firmer brake applications. Watch for a vibrating pedal, pulling to one side, scraping noises and a brake that keeps dragging after you release it. Also test the electric parking brake. Afterwards, inspect the brake discs, pads, lines and underside on the lift. From the outside of a wheel, not everything is visible.
A practical checklist for the used Giulia
Use this order during the viewing. That way you check the car before a warm engine can hide possible faults:
- Compare the VIN, mileage, invoices and applicable recalls.
- Check the car cold for fluid loss, moisture and visible damage.
- Have the battery and charging system tested and read the control units.
- Test the lights, infotainment, cameras, sensors, climate control and windows.
- Drive long enough to assess the engine, automatic gearbox, brakes and steering when warm.
- After the drive, check the cooling system again and have the car inspected on a lift.
Check the reversing camera several times by engaging reverse gear. Also test the operation of the driver assistance systems and see whether warnings return. On a Quadrifoglio, the condition of the tyres and brakes, maintenance of the 2.9 V6 biturbo and any signs of track use should also be included in the pre-purchase inspection.
Avoid an expensive repair after purchase
Do not assume without diagnosis that a fault is caused by the battery. Is the automatic gearbox jerking, is coolant disappearing, are fault codes returning or is there water in the cabin? First ask for a diagnosis and a repair quote. Make sure the fault is fixed before delivery, or include the proven cost in your offer. If the seller refuses a cold start or an independent inspection, you are missing information that is needed for the purchase.
A well-maintained Giulia is identifiable by verifiable documentation and by a car that shows no unexplained faults during inspection. The Carnews website offers plenty of information about Giulia problems, maintenance and other topics for car enthusiasts. See which points are relevant to your version before deciding.
Frequently asked questions
On early Giulia models, the main areas of concern are at the front: check the wishbones, ball joints and steering components for play, and listen for creaking over speed humps, steering vibrations, pulling to one side and uneven tyre wear. No specific structural weak point of the subframe is mentioned, but it should still be inspected on a lift for damage and mounting play.
The infotainment module is mainly affected by start-up problems, frozen software, connectivity issues with Bluetooth/Apple CarPlay/Android Auto and a screen or reversing image that cuts out. The instrument cluster mainly shows multiple simultaneous or false warning messages and persistent warning lights. A weak 12V battery, outdated software and faulty wiring, connectors or circuit boards are common causes.
Colour differences, overspray on seals, uneven panel gaps and unusual welding or repair traces on the rear wings suggest possible hidden damage. Dents, distortions, fresh coating or damage to the floor pan are also suspicious, especially on a Quadrifoglio that may have been used intensively or on track.









